Installing the Uppababy^® Car Seat Adapter

Step 1

Remove Both Accessory Plugs

Apply the stroller parking brake. Remove both plugs from the accessory attachment locations by depressing the button and sliding them out.

Pro tip: A great place to store these plugs is in the zipper pocket on the back of the under stroller storage.

Step 2

Insert Adapter

Insert the Uppababy^® adapter fully (arrows towards stroller nose) and secure the latch on both sides around the stroller frame. Pull upwards on each adapter to test attachment.

Step 3

Recline Seatback

If needed, recline the stroller seat, using the button on the back of the seat, to make room before installing the car seat.

Step 4

Install Infant Car Seat

Lower the car seat, making sure it's facing toward the back of the stroller, onto the adapter and press down firmly until you hear a loud 'CLICK' indicating the car seat is safely installed.

Pro tip: Test the car seat is securely attached by pulling up on the car seat. If the car seat isn't attached, recline the stroller seat back more to allow room for secure attachment.

Removing the Car Seat

To remove the Uppababy^® infant car seat, you need to depress the button on the back side near the canopy. Then pull upwards from the handle.